HP Black and Color Cartridge
14

PLEASE NOTE: If you have tried printing with your cartridge completely out of ink, you may have damaged the printhead. Inkjet printers work by heating a resistor inside the printhead which heats the ink before it is sprayed onto the paper. If there is no ink to keep the resistors cool, you stand the chance of frying them.

Always refill before you are completely out of ink.

Instructions:
Important: Wear old clothes and work over newspapers or paper towels.

1. Seal the outlet hole(s) with the aluminum tape provided.
2. Fill the syringe with 10 ml. of black ink or 5 ml. of color ink. Push needle through the label into the sponge of the correct filling hole. On the color cartridge the inks from left to right are, CYAN - MAGENTA - YELLOW (You can double check the ink colors by looking at the outlet ports before putting on the tape).
3. Very S-L-O-W-L-Y inject ink into the sponge until the cartridge is full. A little ink might come out of the top when full, so cover up the other two holes while filling one.
4. When finished, seal the Filling Hole(s) made in the top label with tape. If the holes are not sealed properly the cartridge will leak.
5. Important - Next, remove the Tape from all exit port(s).
Replace the cartridge and run 1-3 cleaning cycles as per printer instructions.
Or print the following page: Black  Color

If necessary, leave the cartridge in the printer for up to 24 hours.

Check your printer's user manual about resetting the ink levels back to full. If your printer does not have this option, then you will need to deactivate the ink level monitor. Click on the following links for instructions.
CP160 Override         D135/155 Override
If you don't do this, once the cartridge reads empty (even though you refilled it) the printer will refuse to print.


A Refill Kit should include Ink plus the following:
1 Syringe/Sharp Needle per color
Aluminum Tape