HP Color Cartridge  
28, 57, 75, 93, 95, 97

PLEASE NOTE: If you have tried printing with your cartridge completely out of ink, you may have damaged the printhead. Inkjet printers work by heating a resistor inside the printhead which heats the ink before it is sprayed onto the paper. If there is no ink to keep the resistors cool, you stand the chance of frying them.

Always refill before you are completely out of ink.

1. Peel off the top label.
2. Refer to the picture, or use toothpicks, to determine which color is where. Tape over the other two chambers.
3. Screw the needle on to the syringe and draw some ink into it. The 28, 57 and 93 cartridges will hold about 5ml, the 75, 95 & 97 about 6ml
4. S-l-o-w-l-y inject ink into each chamber until the sponge is full. A little ink may come out the top.
5. Immediately blot away any hanging drops of ink that may form on the print head, as the ink can migrate up into an adjacent chamber and cause contamination.
6. Repeat steps 2, 3, and 4, using a different syringe/needle for each color. Remove the tape once you are finished with all three holes.
7. When finished, replace the label if you wish. It will make no difference in the printing.
8. Set the cartridge on something (ie: block of wood) that will allow the printhead to hang off the edge, allowing any excess ink to drip onto a paper towel. Let it sit until the cartridge stops dripping. Do not allow the printhead to touch the paper towel because the ink will be wicked out.

Replace the cartridge and run 1-3 cleaning cycles as per printer instructions.
Or print the following page: Color

If necessary, leave the cartridge in the printer for up to 24 hours.

The cartridge will print just like a new one. Even though the cartridge prints good, the ink level gauge will not read full after a refill. To reset the ink level gauge back to full, follow these instructions. **Pertains to the 28 and 57 cartridges**

Instructions:
Important: Wear old clothes and work over newspapers or paper towels.

1. Remove the cartridge from your printer.
2. Place a piece of tape over the left contact, as shown.
3. Place the cartridge back into the printer.
4. The printer will perform an alignment page…....when finished, remove the cartridge.
5. Place a piece of tape over the right contact, as shown.
6. The printer will perform an alignment page…....when finished, remove the cartridge.
7. Remove both pieces of tape (make sure there is no residual tape left on the cartridge)
8. Place cartridge into printer. It should now read Full.

A Refill Kit should include Ink plus the following:
1 Syringe/Sharp Needle per color